Applicable Standards
BS EN 61537IEC 61537Loading
Please wait while the page is prepared.
Please wait while the page is prepared.
Cable Management Systems
Covers, reducers, separators, joints, clamps, anchors and installation accessories for complete cable-system integration.
Ten catalogue series make up the Accessories & Fixings range — covers, reducers, separators, joints, clamps, anchors and installation fixings used across every Cable Management System.
Screw Sets, Threaded Rods, Steel Anchors, Plastic Strip Protector, Galvanized Paint
Screw sets, threaded rods, steel anchors, plastic strip protector and galvanized paint for general fixing.
Cover for Cable Tray and Cover Clamps
Covers, duct-type roofed covers and clamping hardware for enclosing cable tray runs.
Reducers
Width-transition reducers for stepping down between tray or trunking sizes.
Separator, End Cap, Level Changer, Direction Changer
Compartment separators, end caps and level/direction-changing elements.
Aluminium Cable Cleats
Aluminium cleats for securing and spacing cables along a route — real size variants, order codes on request.
Cable Crochets (C Profile / Angle)
C-profile and angle crochets for direct cable support off structure.
Granite Mounting Elements
Mounting elements for fixing support systems into granite and stone surfaces.
Cable Drum Support Equipment
Support equipment for holding and paying out cable drums during installation.
Mechanical Dilatation Element
G1-EXP expansion-joint elements accommodating thermal movement along a containment run.
Shaft Access Cover
Custom, made-to-order access covers for cable shafts and vertical routing points.
These accessories and fixings are used across the following containment and support systems.
Get technical support with fixing selection, load ratings, materials, finishes and project-specific configurations.